AGFA DX-D 400 User Manual page 135

PUSH-BUTTONS
1
1
1 +
2
1
+
1
+
2
1
+
2
2
2
+
2
+
Note.- - Workstation data such as X-ray Tube, Device, Ion Chambers, etc... must be registered.
6.1.3 FOCAL SPOT INDICATORS AND SELECTORS
.
Note
.
Note
0232F EN 20191213
Note in the following table the configuration of the Workstation assigned for
each push-button.
WORKSTATION (Tube, Device, etc.)
LARGE FOCAL SPOT: Indicates that the "Large Focal Spot" of the X-ray Tube
has been selected.
SMALL FOCAL SPOT: Indicates that the "Small Focal Spot" of the X-ray Tube
has been selected.
FOCAL SPOT SELECTORS: Each push-button selects the related Focal Spot
of the X-ray Tube, keeping kVp and mAs constant (maximum mA available and
minimum Exposure Time).
The Focal Spot change can be done whenever the present
conditions of the X-ray Tube allow it.
The mA station set for the Focal Spot change is configured by the
field engineer during the installation.
The Focal Spot may also be selected:
according to the selected mA station.

by pressing "ON" + "mA or mAs increase" push-buttons to select Large

Focal Spot, or by pressing "ON" + "mA or mAs decrease" push-buttons
to select Small Focal Spot.
DX-D 400
User Manual
125