AGFA DX-D 400 User Manual page 41

GUIDANCE AND MANUFACTURER'S DECLARATION - - ELECTROMAGNETIC EMISSIONS
The DX- -D400 radiographic room is intended for use in the electromagnetic environment specified below.
The customer or the user of The DX- -D400 radiographic room should assure that it is used in such an environment.
Emissions test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000--3--2
Voltage fluctuations/flicker emissions
IEC 61000--3--3
NOTE - In accordance with Standard IEC 61601-1-2:2014, the emissions characteristics of this equipment make it suitable for use in industrial areas
and hospitals (CISPR 11 Class A). If it is used in a residential environment (for which CISPR 11 Class B is normally required) this equipment might not
offer adequate protection to radio-frequency communication services. The user might need to take mitigation measures, such as relocating or
re-orientating the equipment.
0232F EN 20191213
It is customer responsibility to assure that this equipment
and vicinity equipment complies the value of radio frequency
interferences shown in General Regulation for safety
according to IEC 60601-1-2: 2007 and 2014 Tables as
described in this section.
The manufacturer is not responsible for any interference
caused by using other than recommended interconnect
cables, accessories and transducers or by unauthorized
changes or modifications to this equipment.
(IEC 60601-1-2:2007 AND IEC 60601-1-2:2014)
Compliance
Group 1
Class A
Class A
Complies
Electromagnetic environment - - guidance
The DX--D400 radiographic room uses RF
energy only for its internal function. Therefore, its
RF emissions are very low and are not likely to
cause any interference in nearby electronic
equipment.
The DX--D400 radiographic room is suitable for The DX--D400 radiographic room is suitable for
use in all establishments other than domestic
and those directly connected to the public
low voltage power supply network that supplies low--voltage power supply network that supplies
buildings used for domestic purposes.
DX-D 400
User Manual
31