AGFA DX-D 400 User Manual page 128

DX-D 400
User Manual
5.8 ERROR CODES
118
Error codes indicate the potential cause of a system failure. Error codes are
shown on the Console, at the same time an alarm sounds. Correct the error
cause and keep touched the "Reset" button until the Console indication
disappears. (Refer to Table 5-1).
All these error codes are preceded by the letter "E" (i.e., E01) and they will
enable the operator to indirectly convey the possible source of error to service
personnel. This may prevent the need for a service call or enable service
personnel to anticipate corrective actions prior to arriving on site.
0232F EN 20191213