Shocks / Springs; Shock Assembly View; Shock Removal / Installation; Shock / Spring Replacement - Polaris RZR PRO XP 2020 Service Manual

STEERING / SUSPENSION

SHOCKS / SPRINGS

SHOCK ASSEMBLY VIEW

q
Front Shock
44 ft-lbs (60 Nm)
Retainer gap should be 180 degrees from spring end.
9.28
q
Rear Shock
74 ft-lbs (100 Nm)

SHOCK REMOVAL / INSTALLATION

1. Elevate the vehicle off the ground to relieve the
suspension load.
2. Support under A-arm or trailing arm.
3. If equipped, disconnect Dynamix electrical
connection and cut cable tie retaining harness to the
shock body.
4. Remove the upper and lower fasteners retaining the
shock and remove the shock from the vehicle.
5. Reverse the procedure to reinstall the shock. Torque
fasteners to specification.
IMPORTANT
Ensure Dynamix equipped models have the harness
properly secured to the shock body.
TORQUE
Front Shock Mounting Bolts ( Top and Bottom):
44 ft-lbs (60 Nm)
Rear Shock Mounting Bolts (Top and Bottom):
74 ft-lbs (100 Nm)

SHOCK / SPRING REPLACEMENT

NOTICE
Rear shock shown.
1. Remove the shock. See Shock Removal /
Installation page 9.28.
2. Remove three fasteners
3. Use spanner wrench (2878925-329) loosen the jam
nut (if applicable) and adjustment ring until the spring
is loose.
9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
q
securing mud guard.
© Copyright Polaris Industries Inc.