Table of Contents
Advertisement
6-4
X.25 Port Parameters (screen 1 of 6)
* R LP: 0
Port: 5
* I /O: V.35
A Port Type
B Phys ical Port In terface
C Blocked Port Flag
D Line S peed
E Modu lo
F Maximum LA PB Window Size
G N 2 Retransmit Coun t
H T1 Retran smit Period (msec)
I
T2 Wait Ack Period (ms ec)
J T3 Lin k Alive Period (sec)
K Logical DCE
L Generate C lock
M R cv Clock (TT) from DTE
Option:
Figure 6-3 Default Configuration Screen for New Port
After making any changes, be sure to press
system memory. Otherwise, the changes will not take effect until
the next re-boot of the FRM.
The entry
identifies the LIC containing the port, and
I/O
– The link was shut down by an on-line command, is undergoing re-
Link_disable
IPL, or has not yet been established.
– Some or all modem controls are missing. (This state is passed through
Failed
while a port is becoming enabled.)
– The link was up, but has gone down.
Link_down
– Level 2 cannot be established.
Disconnect
– The necessary level 1 modem signals are present, and level 2 link is up.
Linkup
– Some state other than those above has been entered.
NA
To configure the port with the parameter values neccessary for your application, go to
the appropriate chapter:
Frame relay
– Chapter 7
X.25
– Chapter 8
SNA
– Chapter 9
BSCI
– Chapter 10
BSCB
– Chapter 11
Async
– Chapter 12
Configure the protocol that will run over the physical port.
Rmtid=nod exyz
Lin k S tate:
Lin k_disab le
Databas e
System Memory
X.25
X.25
V.35
V.35
N
N
9600 bp s
9600 bp s
8
8
7
7
5
5
2000
2000
1000
1000
10
10
N
N
N
N
N
N
from Main Menu
[A],[C],[A]
Link State
Frame Relay Module 4.0 User Guide, Rev 01
to update the
[F7]
will be one of these:
Advertisement
Table of Contents
