Table of Contents
Advertisement
Displaying SDLC PU Status
Information in this Display:
19-20
To display the status of all PUs on an SNA port, press
plays Menu. When prompted, enter the RLP and port numbers.
SDLC PU Status Disp lay for RLP: 0 Port: 2
Station A ddress
D1
D2
Figure 19-10 SDLC PU Status Display
– (specified when configuring the SNA port) identifies the PU,
Station Address
and must match the
uration. (The station address is usually set to
and in series
C1, C2, C3
– PU name configured in the PU parameters in the SNA Port record.
Name
State
– will be one of these:
Active
Inactive
Never_Activated
Pending_Contact
Pending_Discontact
Inoperational
N ame
State
Pud 1
Never_Activated
Pud 2
Active
[C],[F],[C]
parameter set in the macro PU in the VTAM config-
ADDR
, etc. for multidrop lines.)
– waiting for Normal Response Mode
– waiting for Normal Disconnect Mode
– due to failure of a higher resource (e.g., port)
at the Protocol Status Dis-
[C]
N ode N ame=node_xyz
from Main Menu
for point-to-point SDLC lines,
C1
Frame Relay Module 4.0 User Guide, Rev 01
Advertisement
Table of Contents
