Table of Contents
Advertisement
Async PAD Type
Devices Connected
Assemble Full Message
Data Forwarding Criteria
Special Forwarding Char
Dynamic Signaling Action
Configuring Subscriber IDs
12-14
defines the PAD type for transparent polled/multipoint async operation:
= normal (X.3)
0
is the number of devices connected to the async port. This value must be
PAD and TPAD.
assembles (if
) incoming packets from the remote device (assuming M-bit is set) into
Y
a complete message before forwarding it to the local async device.
This function works only if the M-bit is set in packets from the
remote device.
specifies (as currently implemented) that the async PAD profile parameters will
determine when data is forwarded.
is not implemented in the current release.
is not implemented in the current release.
This operation configures the called and calling addresses that will be used in X.25
call setup if SNA is being transported over a logical X.25 port. To complete the con-
nection, the software must recognize where the call is coming from (calling address)
and where it is going (called address).
To display a list of current Subscriber IDs (addresses), press
Routing Paths Menu (or
To add or change a Subscriber record, press
Menu. When prompted, enter a Subscriber ID of up to 15 digits. (ID conventions are
described on on
page
8-22.)
= HPAD
1
from the Main Menu).
[A], [D], [A]
at the Connections and Routing Paths
[B]
= TPAD
2
at the Connections and
[A]
Frame Relay Module 4.0 User Guide, Rev 01
for X.3
1
Advertisement
Table of Contents
