Ip Interface Parameters; Frame Relay Ip Interface Parameters - Cabletron Systems FRM User Manual

Frame relay module for the smartswitch 9000
Hide thumbs Also See for FRM:
Table of Contents

Advertisement

IP Interface Parameters

Configuring IP
To delete a primary address (
deleting the group of associated secondary addresses, do this:
1.Select one of the secondary addresses to be the new primary.
2.Delete that secondary address.
3.Reconfigure the
was deleted.
Table 13-2 through Table 13-4 list all possible IP Interface parameters. (Some will not
be displayed, depending on how others are configured.) Because several parameters
apply to more then one interface type, descriptions of all IP Interface parameters
follow
Table
13-4.
Table 13-2 Frame Relay IP Interface Parameters
Parameter
Maximum Tr ansmission Unit
Routing Metric Count
ICMP Redirects
RIP Support
RIP Flash Updates
(sec)
RIP Full Updates
(sec)
Priority
Bandwidth Allocation Group
Interface Type
Source Card
Source Port
Source DLCI
Enable Inverse ARP
Destination IP Address
Unnumbered Interface
Source IP Address
Networ k Mask
Make sure the frame relay port is not configured (in the Port record) for
1
Make sure the DLCI is not part of a
2
relay PVC
.
for new interfaces,
Y
3
FRM software is installed.
255.255.255.255
4
See the caution following these footnotes. The default value of
5
configured automatically, to reflect the appropriate address class, after the
Address
is specified. If the interface is configured as unnumbered (and, therefore, no
Source IP Address
the numbered interface that is assigned.
Source IP Address
Source IP Address
Valid Values
1–4096
0–255
Y/N
0
(Enabled),
2
(Disabled)
5–300
10–300
0–9
1–16
FRL
(frame relay)
0–2
1
0–7
2
16–991
Y/N
1.0.0.0–223.255.255.255
Y/N
1.0.0.0–223.255.255.255
255.0.0.0–255.255.255.255
frame relay DLCI backup group
for interfaces already configured when the current release of
N
is valid only on a point-to-point interface.
is configured), the default value of
on the first screen) without
to specify the secondary address that
Default Value
1500
0
Y
1
(Rcv only),
0
(Enabled)
10
30
5
1
FRL
0
0
16
see note
none
see note
none
4
255.0.0.0
backup use only.
or intra-nodal
Network Mask
will be taken from
Network Mask
3
3
5
frame
will be
Source IP
13-7

Advertisement

Table of Contents
loading

Table of Contents