Table of Contents
Advertisement
LLC2 Interface Parameters
Interface Type
Blocked Port Flag
Port Priority
Path Cost
9-28
The following table lists parameters for all interface types. Explanations of some
parameters follow the table.
Parameter
Interface Type
Blocked Port Flag
Port
Priority:
Native LLC2 format:
8025_SRB/8023_TB format:
Path
Cost:
Native LLC2 format:
8025_SRB/8023_TB format:
Pr iority
LAN Card
RLP
Por t
DLCI
Format
Bandwidth Allocation Group
Host MAC Address
Session Type
LAN ID
1 Make sure the port is not configured for backup use only. (See
2 Make sure the DLCI is not part of a
of a
frame relay PVC
3 See caution at explanation.
4 Configured in
LLC2 Host
record, it must also be bit-swapped here.
5 The LAN ID on an originated LLC2 interface must match the LAN ID on the corre-
sponding terminated interface. Also, (other than the exception of originated/terminated
pairs) each LAN ID must be unique among all LAN IDs throughout the network on
which this node will operate.
identifies whether the interface is on a LAN or a frame relay network.
will cause the port to be enabled (
remain in that state until this parameter is changed or (frame relay interface only) an
on-line enable (
[B], [B], [C]
Menu) is performed.
will become the first octet of the
lower the number, the higher the priority that the interface will be given among other
interfaces in the spanning tree.
Table 9-5 LLC2 Interface Parameters
Valid Values
Ethernet, TokenRing, FRL
Y/N
n/a
0–255
n/a
1/1000 FR port line speed
0–9
0
0–2
1
0–7
16–991
Native LLC2,8025_SRB,
8023_TB
1–16
valid host address
Originated, Terminated
000–fff
frame relay DLCI backup group
(page 7-19).
file (see page 9-19). If the address was bit-swapped in the Host
) or disabled (
N
from the Main Menu) or disable (
field in Spanning Tree Protocol messages. The
Port ID
Default Value
FRL
(frame relay)
N
128
15625
0
0
0
0
2
16
3
Native LLC2
1
4
400000000001
Originated
5
(hex)
fff
page
7-17.)
(page 7-21) or part
) at node IPL. The interface will
Y
from the Main
[B], [B], [A]
Frame Relay Module 4.0 User Guide, Rev 01
Advertisement
Table of Contents
