Table of Contents
Advertisement
Configuration
FRM alarm, or event, messages can be displayed locally (see
page 21-3), as well as sent to an async terminal, a serial or parallel printer, another
node, or any other device capable of interpreting event messages.
Events parameters are set in Node Defaults (
message file ERRMSG.TXT contains the format of events for message construction.
To configure an FRM to collect events from other Cabletron frame relay access
devices (FRM, SmartSwitch 1800, FRX4000, FRX6000), do the following in Node
Defaults:
1. Set
Collecting Node
be reconfigured.)
2. Configure
Max Congestion
Chapter 4.
3. Specify a
Collecting Node ID
default password is recommended.) These will be used by other nodes to place a
call.
4. If you want this node to route all events (including its own) to another device
(such as a printer), specify a
(Password). (Keeping the default password is recommended.) Note that the
Pwd
password serves no function if a printer is specified.
5. If you want this node to route all events to a second device as well as that defined
in step 3, specify a
(Password). (Keeping the default password is recommended.)
At each node that will send its events to the collecting node:
1. Set
Collecting Node
2. Specify the
Primary Alarm Output ID
match the
Collecting Node ID
lecting node.
3. In the Port record for the physical or logical X.25 port that will be used for inter-
node connections, configure
parameter in the collecting node.
[A], [A], [C]
to
. (The default setting is
Y
and
Line Idle Timer
and
Collecting Node Pwd
Primary Alarm Output ID
Secondary Alarm Output ID
to
.
N
and
Primary Alarm Output Pwd
and
Collecting Node Pwd
Maximum LAPB Window Size
Chapter 21
System Events
"Displaying
from the Main Menu). The
, so the parameter may have to
N
according to the guidelines in
(Password). (Keeping the
and
Primary Alarm Output
and
Secondary Alarm Output Pwd
(Password)
(Password)
of the col-
to match the same
Events" on
to
Advertisement
Table of Contents
