Table of Contents
Advertisement
Configuring Subscriber IDs
9-14
This operation configures the called and calling addresses that will be used for con-
necting to an LLC2 host, or in X.25 call setup if SNA is being transported over a
logical X.25 port. To complete the connection, the software must recognize where the
call is coming from (calling address) and where it is going (called address).
To display a list of current Subscriber IDs (addresses), press
Routing Paths Menu (or
To add or change a Subscriber ID, press
Menu. When prompted, enter a Subscriber ID of up to 15 digits. (ID conventions are
described on
page
8-22.)
SV C Sub scriber Main ten ance
*
Sub scriber ID
A Sub scriber Name
B Routing Algorithm
C Systematic Redirection
D Redirect on Busy
E Redirect on Ou t of Order
F
Conn ection Priority
G Routing Path s
H Redirection Ad dres ses
Option:
Figure 9-4 Typical SVC Subscriber Screen
Pressing
will display routing paths, which link the subscriber with one or more
[G]
ports. Pressing
will display the addresses used for call redirection. (These
[H]
addresses are valid only if
first screen.) Parameters for all three screens are described following
from the Main Menu).
[A], [D], [A]
at the Connections and Routing Paths
[B]
0100012345
su b1
0, Rou nd Robin
N
N
N
0
[A],[D],[B]
is specified for one or more of items C, D, and E on the
Y
at the Connections and
[A]
Nod e Name=nod exyz
from Main Menu
Table
Frame Relay Module 4.0 User Guide, Rev 01
9-3.
Advertisement
Table of Contents
