Table of Contents
Advertisement
Introduction
The FRM supports BSC (binary synchronous communication) Batch ports, used to
interconnect IBM 2780/3780 devices over frame relay or X.25. IBM's DSP (Display
System Protocol) allows a host-to-TPAD connection across the network.
To run BSC Batch in an FRM, make sure the following are properly configured in the
database:
Node
parameters, which is general configuration that must be done no matter
which protocols will be run in the node. See Chapter 4.
RLPs
that will contain the interface(s) to the user device(s), plus Line Interface
Card(s) supporting the ports that will be the interfaces. See Chapter 5.
Loaded
Protocol(s): BSCI, as well as the transport protocol: frame relay or
X.25. See Chapter 5.
Frame relay port(s)
relay PVC. See Chapter 7 (frame relay) or Chapter 8 (X.25).
BSC Batch port(s)
Subscriber IDs
(page 11-7) to identify the user devices.
Configuring BSC Batch
and/or
X.25 port(s)
that will connect to a network or frame
(page 11-2) that will connect to the user devices.
Chapter 11
Advertisement
Table of Contents
