Table of Contents
Advertisement
IP Status Displays
IP Routing Table
Information in this Display:
19-24
– The address is used for terminated LLC2 traffic.
LLC2
All SNA frames (identified by SAP multiples of 4) will be
handled by LLC2, rather than bridged directly.
– The LLC2 address has been explicitly configured for a Host
Configured
record.
– The addresses is accessible via a native LLC2 interface.
Native
Discovery Pending
received frame, and the FRM software is trying to find the correct Bridge
port for that address. (Therefore, the port will be identified as
unknown, until it is discovered.)
Don't Forward
with this flag are destined for the local bridge, or are reserved functional
addresses defined in the 802.1d specification and IBM Token Ring archi-
tecture.
To display a list of active IP routes, press
from the Main Menu).
[F], [G], [A]
– Destination IP address.
Destination
– IP address of router that provides access to the destination device.
Gateway
(This corresponds to the
13-16).
– (Reference) Internal count of the number of places the route is currently
Ref
being used in the FRM software. The route cannot be removed if this count is
greater than zero.
– Number of times the route was used to send a packet.
Use
:
= Route is on a LAN interface.
Flags
C
= Route is via a remote gateway (hop count is greater than zero).
G
= Route is a Host route.
H
= Route is a
S
= Route is operational.
U
– (Interface) Identifier used in the IP Route Display. Each entry is the
Intf
interface number preceded by the interface type, which is one of these:
Frame relay
fr
Loopback
lo
– Network mask, used during routing to determine the portion of the
Netmask
address associated with the network.
– The MAC address was the destination address in the
– Frames to the address will not be forwarded. Addresses
at the IP Status Displays Menu (or
[A]
parameter in static IP Routes (described on page
Router
static
route.
X.25
Ethernet
x
en
Token Ring
tr
Frame Relay Module 4.0 User Guide, Rev 01
, or
Unk
[C],
Advertisement
Table of Contents
