Configuring Ipx Filter Applications; Typical Ipx Filter Applications Record - Cabletron Systems FRM User Manual

Configuring IPX Filter Applications

14-8
IPX Filter Applications determine how filters will be used at the interface. To review
existing applications, press
Menu (or
[A], [A], [E], [F], [C]
at the Configure Filter Definitions and Applications Menu. When prompted, enter:
[D]
Interface number:
:
Filter Category 0
: (inbound) or
Direction i
Any other requested information, referring to
IPX Filter A pplications
* Interface N umber
* Filter C ategory
* Direction
A Permit
B Filter A pplication 1
C Filter A pplication 2
D Filter A pplication 3
E Filter A pplication 4
F Filter A pplication 5
G Filter A pplication 6
H Filter A pplication 7
I Filter A pplication 8
J Filter A pplication 9
K Filter A pplication 10
2 Page 2
Option:
Figure 14-3 Typical IPX Filter Applications Record
Up to 100 filters can be configured, displayed over 9 "pages" (screens).
When finished configuring filter definitions and applications, perform an on-line
update to make the changes effective immediately. Press
and Applications Configuration Menu. The changes will be sent to the software
running on the RLP(s).
[C] at the Configure Filter Definitions and Applications
from the Main Menu). To configure an application, press
0–63 . (The default is 0
= RIP, = SAP, = Packet,
1 2
(outbound). (The default is
o
2
0 RIP
I–I nbou nd
Y
0
0
0
0
0
0
0
0
0
0
[A],[A],[E],[F],[D]
.) This identifies the virtual interface.
= RIP Router. (The default is
3
.)
o
Table 14-6.
from Main Menu
at the Filter Definitions
[E]
Frame Relay Module 4.0 User Guide, Rev 01
.)
0