Table of Contents
Advertisement
RLP and Protocols
5-2
The RLP file contains the information shown in
the RLP screens, press
To display a table of memory usage, press
information, in conjuction with information in the release notes, can help in planning
the number of protocols to run.
To configure a protocol, press
for an
RLP number
(see
RLP C onfiguration
* RLP:
0
* Statu s: In stalled
* RLP Typ e: R LP
* Line In terface Card 1: V.35
* Line In terface Card 2: V.35
F Protocol 1:
G Protocol 2:
H Protocol 3:
I
Protocol 4:
J Protocol 5:
K Protocol 6:
L Protocol 7:
M Protocol 8:
N Protocol 9:
Op tion :
Figure 5-2 RLP Configuration Menu
To add or remove a protocol, press the letter corresponding to the protocol number.
The protocol in the
Configured
(See
Table
5-1.)
After all desired changes have been made, press
the FRM as follows:
Rebooting will clear all connections on this device. However, the
device must be rebooted to implement the change.
1. Press
.
[F10]
2. When asked:
Reboot the Node?
3. Type
restart [Enter]
, then
from the Main Menu.
[A]
[B]
[C]
at the RLP Configuration Menu. When prompted
[B]
Figure
5-1), type a number:
* Memory Configuration: 8 Meg
Con figu red
Load ed
X.25
X .25
FRL
FRL
As ync
A sync
SD LC
S DLC
IP
I P
Non e
Non e
Non e
Non e
[A],[B],[B]
column will change to the next valid one.
, press
.
[Y]
.
Figure 5-2
for each RLP. To access
at the RLP Configuration Menu. This
0–2
, then press
[Enter]
Node N ame=nodexyz
from Main Menu
to save the changes, then reboot
[F3]
Frame Relay Module 4.0 User Guide, Rev 01
.
Advertisement
Table of Contents
