Table of Contents
Advertisement
IPX Filter Applications Parameters
Permit
Filter "n"
Configuring IPX Interfaces
Configuring IPX
Table 14-6 IPX Filter Applications Parameters
Parameter
Permit
Filter "n"
Determines whether the traffic defined by the
denied passage across the interface.
corresponds to the
Filter ID
An IPX interface allows an FRM to connect to a Novell IPX network. Press
IP/LLC2/BRIDGE/IPX Interfaces Configuration Menu (or
Main Menu) to display configured IPX interfaces.
To configure an interface, press
ration Menu. When prompted, enter an
sequential number to identify the interface.)
The display depends on the interface; the following figure shows an example, and
Table 14-7
through
Table 14-9
IPX Interface C onfiguration
*
In terface Nu mber
A Block ed Port Flag
B In terface Type
C Frame Type
D Maximu m Trans mis sion U nit
E IPX Network Add ress
F
Priority
G Band width Allocation Group
H Port Diagnos tics Enabled
I
NetBIOS Enab led
J
NetBIOS Hops
K Periodic RI P Enabled
L Periodic RI P Timer (s ec)
M Periodic SA P Enabled
N Periodic SA P Timer (s ec)
O Ad dition al IPX Parameters
Op tion :
Figure 14-4 IPX Interface Record Example
Valid Values
Y/N
0–65535
Filter "n"
s in the
IPX Filter Definitions
at the IP/LLC2/BRIDGE/IPX Interfaces Configu-
[F]
Interface Number
list the parameters for all interface types.
2
N
Ethern et
TYPE_II
4096
00000001
0
1
Y
N
8
Y
60
Y
60
[A],[C],[E],[F]
Default Value
N
0
entries will be permitted or
file. (See page 14-3.)
[E]
from the
[A], [C], [E], [E]
:
. (This is merely a
0–63
from Main Menu
at the
14-9
Advertisement
Table of Contents
