Table of Contents
Advertisement
Configuring IPX Node Defaults
IPX Node Defaults Parameters
Internal Network
Gap
Router Name
14-2
Press
at the Configure IP/LLC2/BRIDGE/IPX Default Parameters Menu (or
[E]
from the Main Menu) to configure default IPX node parameters.
[A], [E], [E]
Con figu re IPX N ode D efau lts
A In ternal Network
B Gap (55ms intervals )
C Rou ter Name
Op tion :
Figure 14-1 IPX Node Defaults Menu
Table 14-1
Parameter
Internal Network
Gap
(55 ms intervals)
Router Name
identifies the node to the IPX network. If fewer than 8 hex digits are entered, leading
zeros will be added.
is the minimum delay between consecutive RIP and SAP (Service Advertising Pro-
tocol) transmissions. This parameter provides compatibility with older Novell servers.
is simply an identifier for the IPX network. It must be unique within the network.
Node N ame=nodexyz
0000001e
1
ip x_rou ter_1
[A],[A],[E],[E]
from Main Menu
IPX Node Defaults Parameters
Valid Values
0–ffffffff
(8 hex digits)
0–100
1–47 characters
Frame Relay Module 4.0 User Guide, Rev 01
[A],
Default Value
00000000
1
none
Advertisement
Table of Contents
