Table of Contents
Advertisement
Testing a Translation Template
8-32
received. The packet matches Template ID
occurs as follows:
User data
99
311012345678
The translated called address is
Press
at the X.25 Address Translation Templates Menu (
[C]
Main Menu) to test a translation template you have created.
When prompted, enter:
. (The default is
RLP:
0–2
:
. (The default is
Port
0–7
:
(incoming) or
Direction
I
to be translated.
Called address
to be translated.
Calling address
Facility length + facility + user data
tocol ID, which must be entered as a hex string.) To specify only user data, at
the above prompt enter
desired user data, including the 4-byte protocol ID.
After you enter this information, the FRM creates a test packet and sends it through
the translation process, and displays the results, as shown in the following example.
Packet Trans lation Tes t
Port:0
Direction :Incoming
Original Packet:
10010B7712345673333333000100000035353535
C alled Add ress :
1234567
U ser Data Protocol ID : 01000000
Facilities:
Trans lation Template:
Template I D:
1234C *U*
C alled Add ress :
L8401X 7
U ser Data Protocol ID : P
Facilities:
P
Trans lated Pack et:
10010B74840133333330000100000035353535
C alled Add ress :
8401
U ser Data Protocol ID : 01000000
Facilities:
S trike any k ey to continu e
Figure 8-11 Address Translation Test Screen
from the packet is appended to the called address
.
31101234567899
.)
0
.)
0
(outgoing). (The default is
O
. (The user data includes four bytes for pro-
for a facility length, nothing for a facility, then the
00
C alling A ddress: 3333333
U ser Data:
55555
C alling A ddress: P
U ser Data:
P
C alling A ddress: 3333333
U ser Data:
55555
[A],[C],[C],[C]
; therefore, a translation
3110*U??
.
[A], [C], [C], [C]
.)
I
N ode Name=n odexyz
from Main Menu
Frame Relay Module 4.0 User Guide, Rev 01
from the
Advertisement
Table of Contents
