Table of Contents
Advertisement
Vary Commands
Modify Commands
C-4
VARY ACT
Function: Changes the desired status of specified PUs to an active state.
Command:
V NET,ACT, ID={linename[,A|U|C],puname}
Options:
= activate all PUs on the line.
A
= activate all PUs on the line whose
U
= activate all PUs except those that have never been activated
C
VARY INACT
Function: Changes the desired status of specified PUs to an inactive state.
Command:
V NET,INACT, ID={linename[,I|R|F],puname}
Options:
= de-activate all PUs on the line immediately.
I
= de-activate, then re-activate, all PUs on the line immediately.
R
= reset all PUs on the line to an inactive state. If appropriate, a
F
de-activate command will be sent.
MODIFY CONFIG
Function: Modifies one or more configuration parameters for a specified PU, or
for a specified line if a PU is not specified. There are two
CONFIG
F NET, CONFIG,ID="nnnn"
in the FRM record for the SNA Port or LLC2 Host (depending on
the parameter). The changes will be in effect until an on-line
database update or re-IPL of the node is performed, or an
F NET, CONFIG,COMMIT
F NET, CONFIG[,COMMIT]
Database value(s) with all changes made since the last
on-line update of the record, or node IPL.
Command:
F NET, CONFIG,ID={linename[,keyword=value],puname
[,keyword=value]}
Keywords when the line is being modified are listed below. If two
words are shown, either can be used. The parameters are described in
Chapter 9.
Keyword(s)
NODATA
NORESP
GENCLCK
RCVCLOCK
ISTATUS
NRZI
SPEED
(
). Of those, activate all whose
NEVAC
commands:
will update the System Memory value(s)
(see below) is sent.
will update the FRM record's
Corresponding Parameter
in the FRM
or
PAUSE
No Data Poll Period
or
ACTIVETO
No Resp Poll Period
or
CLOCKINGGenerate Clock
Rcv Clock (TT) from DTE
Blocked Port Flag
NRZ
Line Speed
ISTATUS = ACTIVE
ISTATUS = ACTIVE
Valid Values
0–125
40–9999
Y/N
Y/N
Y/N
Y/N
(see
Frame Relay Module 4.0 User Guide, Rev 01
.
.
MODIFY
,
COMMIT
(ms)
(ms)
page
9-8)
Advertisement
Table of Contents
