Logging Into The Main Menu; Port Status Display - Cabletron Systems FRM User Manual

Logging into the Main Menu

2-4
Configuration (described in Section II) and management (Section III) operations are
accessed via a menu structure, using the keyboard and video device. Once the FRM
has been configured and is operational, it does not need the keyboard and video
device; however, they are necessary to get the unit up and running.
To protect the FRM from unauthorized access, entry to the menu operations requires
a password.
When running outside the menu operations, a display will be similar to the following
figure, and will show the current status of all ports on the node. (This display is
described in detail on page
Port Status D is play (Page 1)
L P Typ e PPS
0 0 FR 62
0 2 FR 112
0 4 S NA 110
0 6 S NA 100
1 0 A SY 0
1 2 FR 200
1 4 S NA 110
1 6 S NA 100
2 0 A SY 0
2 2 FR 200
2 4 S NA 110
2 6 S NA 100
0 Eth 0
Figure 2-2 Port Status Display
Node Name
board and screen. This will generally be a directly connected node, in
which case the ID will be the
file (described in Chapter 4). If an operator takes
another node (described on page 18-1),
configured in Node Defaults on the controlled node. Any config-
Control ID
uration or control operations will affect that node rather than the local one.
If the controlled node has a display screen, the message
control. Keyboard blocked by id="n"
Remote Control ID
After the operator presses
page 2-9), the Main Menu
19-2.)
Conn # State L P Type PPS
4 Op erational 0 1 SNA 127
7 Op erational 0 3 SNA
3 Op erational 0 5 X25
8 Op erational 0 7 SNA 120
0 Lin k_disab le 1 1 X25
1 Op erational 1 3 FR
3 Op erational 1 5 X25
8 Op erational 1 7 SNA 120
0 Lin k_disab le 2 1 X25
1 Op erational 2 3 FR
3 Op erational 2 5 X25
8 Op erational 2 7 SNA 120
at the upper right dentifies the node under control of the key-
Node Name
of the controlling node.
at the screen in Figure 2-2 and enters a
[F1]
(Figure 2-3) will appear.
Nod e Name=n ode_xyz
Conn # State
12 Op erational
60 6 Op erational
87 5 Op erational
13 Op erational
88 4 Op erational
220 2 Op erational
87 5 Op erational
13 Op erational
88 4 Op erational
220 2 Op erational
87 5 Op erational
13 Op erational
configured in the Node Defaults
Remote Control
will become the
Node Name
Under remote
will be displayed, where "
9W004 4.0 User Guide, Rev 01
of
Remote
" is the
n
pass word (see