Table of Contents
Advertisement
Configuring Port Statistics Thresholds
20-4
For each port statistic, you can specify a threshold that, when crossed, causes an alarm
to be sent to the collecting node.
Press
at the Statistics Menu. When prompted, enter:
[A]
:
for Port.
Statistic level
P
:
on FRM/2/3,
RLP
0
Port
:
0–7
. (Default is
A menu similar to the following figure will be displayed.
Port Statistics (Th resh old s)
RLP: 0
Port: 1
A R eceived frames/Sec (*10)
B Trans mitted frames/Sec (*10)
C R etran frames/Sec (*10)
D FCS errors/Sec (*10)
E Logical rejects /S ec (*10)
F Trans mit error ratio
G R eceive error ratio
H % Receive port u tilization
I
% Tran smit p ort utilization
Option:
Figure 20-4 Port Statistics Configuration Menu
Changing a threshold changes the database value. Press
change to system memory.
A threshold is either a number or a percentage, depending on the statistic. The valid
range for any statistic is
tistic crosses the threshold (in either direction), an alarm is generated.
on FRM. (Default is
0–2
0
.)
Databas e
System Memory
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
(Default =
) When the measured value for the sta-
0–65535.
0.
.)
0
Node N ame=node_xyz
[E],[A]
from Main Menu
[F7]
Frame Relay Module 4.0 User Guide, Rev 01
to write the
Advertisement
Table of Contents
