Table of Contents
Advertisement
Configuring RLP Statistics Thresholds
20-2
Retransmitted frames per sec (*10)
RLP per second over the five-second reporting interval, multiplied by 10. If the
value is consistently greater than zero and there are no other problems, you
should increase the
For each RLP statistic, you can specify a threshold that, when crossed, causes an alarm
to be sent to the collecting node.
Press
at the Statistics Menu. When prompted, enter:
[A]
:
for RLP.
Statistic level
L
:
on FRM/2/3,
RLP
0
A menu similar to the following figure will be displayed.
R LP Statistics (Th resh old s)
R LP: 0
A Percentage of Buffers in Us e
B Numb er of Queued Mess ages
C Received frames/Sec (*10)
D Tran smitted frames/Sec (*10)
E Rejected frames/Sec (*10)
F Retran smitted Frames /S ec (*10)
Option:
Figure 20-2 RLP Statistics Configuration Menu
Changing a threshold changes the database value. Press
change to system memory.
A threshold is either a number or a percentage, depending on the statistic. The valid
range for any statistic is
tistic crosses the threshold (in either direction), an alarm is generated.
– is the number of frames retransmitted by the
timer (
T1
Retransmission Period
on FRM. (Default is
0–2
Datab ase
Sys tem Memory
0
0
0
0
0
0
0
0
0
0
. (Default =
) When the measured value for the sta-
0–65535
0.
) in the Port record.
.)
0
Nod e Name=n ode_xyz
[E],[A]
from Main Menu
[F7]
Frame Relay Module 4.0 User Guide, Rev 01
to write the
Advertisement
Table of Contents
