Table of Contents
Advertisement
13-8
If a Source IP Address is specified/changed, the Network
Mask will automatically change to a default value appro-
priate for the new address. For this reason, configure the
Source IP Address first, then the Network Mask.
Table 13-3 X.25 IP Interface Parameters
Parameter
Maximum Transmission Unit
Routing Metric Count
ICMP Redirects
RIP Support
(sec)
RIP Flash Updates
(sec)
RIP Full Updates
Pr iority
Bandwidth Allocation Group
Interface Type
Destination IP Address
Unnumbered Interface
Source IP Address
Network Mask
Source Subscr iber
Destination Subscriber
(sec)
SVC Retry Timer
(min)
SVC Idle Timer
Max VCs to Establish
PVC Connection
for new interfaces, N for interfaces already configured when the current release of
Y
1
FRM software is installed.
is valid only on a point-to-point interface.
255.255.255.255
2
See the caution following these footnotes. The default value of
3
configured automatically, to reflect the appropriate address class, after the
is specified.. If the interface is configured as unnumbered (and, therefore, no
Address
is configured), the default value of
Sour ce IP Address
the numbered interface that is assigned.
If a
Source IP Address
will automatically change to a default value appropriate
for the new address. For this reason, configure the
IP Address
These addresses must also be configured in Subscriber ID records (see
4
cannot contain wildcards. In the record for the Source Subscriber, do not configure any
Routing Path. In the record for the Destination Subscriber, configure
as the node, RLP, and X.25 port that will be used for the physical interface. (That RLP
does not need to be the same one that has IP installed.)
Valid Values
1–4096
0–255
Y/N
(Enabled),
(Rcv only),
0
1
(Disabled)
2
5–300
10–300
0–9
1–16
X.25
1.0.0.0–223.255.255.255
Y/N
1.0.0.0–223.255.255.255
255.0.0.0–255.255.255.255
valid subscriber address
valid subscriber address
5–60
0–5
1–8
Y/N
is specified/changed, the
first, then the
Network Mask
Frame Relay Module 4.0 User Guide, Rev 01
Default Value
1500
0
Y
(Enabled)
0
10
30
5
1
n/a
none
1
see note
none
2
3
255.0.0.0
4
none
4
none
20
1
1
N
will be
Network Mask
Source IP
will be taken from
Networ k Mask
Network Mask
.
page
8-21), and
1st Routing Path
Source
Advertisement
Table of Contents
