Table of Contents
Advertisement
Displaying Port Signals
Information in this Display
19-6
This display lists basic configuration and line status for all serial ports on a specified
RLP, as well as signal states (on/off) at the physical interfaces.
Press
at the Status Displays Menu and, when prompted, enter an RLP number:
[D]
. The display will show the first four ports, and pressing
0–2
other four ports.
Line Process or Status
Port Nu mber:
Phy Interface:
X .21
Port Con fig:
Logical Inter:
DTE
Line S peed :
1.008M
Line S tatus:
Oper
TD(2)
RD (3)
OFF
RTS (4)
OFF
CTS (5)
OFF
DS R(6)
DC D(8)
TC(15)
RC (17)
DTR (20)
F2:Next R LP Card
PgUp:Firs t 4 Ports
Figure 19-5 Port Signals Display
– is self-explanatory.
Port Number
– is the type of connector on the I/O cable exiting the port's I/O box
Phy Interface
connector toward the subscriber device. (This information is taken from the Port
record.)
Port Config
– is the port type (
record. If no record has been created for this port,
line and the one below it.
– is the logical interface,
Logical Inter
If no record has been created for this port,
the one above it.
– is the speed configured in the Port record.
Line Speed
:
Line Status
Failed
Disconnect
Restart
Not_configured
Operational
RLP: 0
I nterface: RS -422
0
1
2
R S-449
FR
No
SN A
Config
D CE
1.472M
Op er
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
F9:Stop R emote
F10:A bort Remote
PgDn :Last 4 Ports
Oth ers:Exit08:14:52
FRL
,
SNA
DCE
(level 2 is down)
(level 2 is up; level 3 is down)
(level 3 is restarting)
(port is not configured)
(level 3 is up)
will display the
[PgDn]
Nod e Name=nod e_xyz
3
X.21
FR
DCE
2.048M
Oper
ON
ON
ON
ON
ON
ON
ON
ON
ON \
[C],[D]
from Main Menu
,
X25
, etc.) as configured in the Port
is displayed on this
No Config
or
, as taken from the Port record.
DTE
is displayed on this line and
No Config
Frame Relay Module 4.0 User Guide, Rev 01
Advertisement
Table of Contents
