Table of Contents
Advertisement
No Response Retry Count
Error Retransmit Count
NAK Retry Count
Subscriber Parameters
Sq
Local Sub
Remote Sub
Atcl
Rtytm
Rty#
Conn ID
Configuring BSC Interactive
mented. The timer will be de-activated on reception of any valid frame from the line
during
.
Link Down
specifies how many times the user device will be polled (if it is not responding) before
control is passed on the next cluster (accompanied by other condition checks).
specifies the number of times the node will resend a block of data after the receiving
device has detected an error in that block.
specifies the number of times the node will send a frame when the receiving device is
unable to acknowledge; that is, returns a NAK to the node.
is a sequence number to ease selection of a line on the screen to change. To move to
another line, press
and enter the sequence number.
[A]
identifies the local device. A
figured for this address.
is the called address used for calls by the local device. A
page 10-8) must also be configured for this address.
If the BSC port is one end of a connection to a logical X.25 port in the FRM, this
address must match a Subscriber ID configured for the logical port.
(Autocall) causes a BSC TPAD to automatically call its HPAD when the controller
(identified by Link Address) becomes active. This parameter has no function if the
port is an HPAD.
is the Retry Timer, which determines the time between autocall retries.
is the maximum number of times an autocall will be sent.
is an internal connection identifier that will link the BSC port with a device configured
in the
BSC Devices
file (described on page 10-11).
Subscriber ID record
(see page 10-8) must also be con-
Subscriber ID record
(see
10-7
Advertisement
Table of Contents
