Table of Contents
Advertisement
Local NetView Access
C-2
The FRM supports a local NetView access function that allows the node operator to
send commands from the node to lines and PUs. This function is only between the
node and lines/PUs—the commands and responses are not transmitted to NetView.
To display the NetView Access Options Menu, press
tions Menu (or
[B], [A], [H]
NetView A ccess Option Menu
A I npu t FileName
B Outp ut FileName
C Write to File
D R ead From File
E R ead From Keyb oard
F Execute Last Comman d
Option:
Figure C-1 NetView Access Options Menu
Commands can be sent individually or via a batch file. You can also create a batch file
made up of commands you send. The supported commands are described later in this
chapter.
The various operations work as follows:
To send commands from the keyboard, select
the desired command(s). If you want to create a batch file of the commands you
send, specify the desired
do not want to create a batch file, make sure
To repeat the last command you entered, press
To send commands from an existing batch file, specify the desired
, then select
Name
and each command after the first one will be executed only after you press
from the Main Menu).
nmvtCmd .in
nmvtCmd .out
OFF
[B],[A],[H]
, then specify
Input File Name
. The commands will be executed one at a time,
Read From File
at the On-Line Node Opera-
[H]
Node N ame=nod e_xyz
from Main Menu
Read From Keyboard
for
ON
Write To File
is
.
Write To File
OFF
.
[F]
Frame Relay Module 4.0 User Guide, Rev 01
, then enter
. If you
Output File
.
[F2]
Advertisement
Table of Contents
