Configuring Async Port Records; Async Pad Port Screen - Cabletron Systems FRM User Manual

Configuring Async Port Records

12-8
Once the necessary Node, Line Processor, and protocol parameters have been con-
figured, press at the Port Configuration Menu (or
[A]
When prompted, enter:
RLP containing the port:
Figure 6-1.)
: . (The default is
Port 0–7
The display for an existing port will show the configured parameter values, while the
display for a new port will show default database values. (See
9.) The following figure is an example of an existing port.
A sync PAD Port Parameters
* RLP: 0 Port: 0 Link State: Lin kup
* I/O:–R S-232
A Port Typ e
B Ph ysical Port I nterface
C Blocked Port Flag
D X.3 Line Sp eed
E Initial Profile Name
F Login Requ ired
G Parity
H DCE Cable A ttach ed
I Mas k Link A larms
J X.25 Parameter Op tion s
K Autocall Op tion s
L Brow se Profile
M Mod em Signal Options
N Disconnect Options
O Asyn c PA D Op tion s
Option:
Figure 12-2 Async PAD Port Screen
If a record does not exist for the async PAD profile identified by
Profile Name
column.
Database
After making any changes, be sure to press
system memory. Otherwise, the changes will not take effect until
the next re-boot of the FRM.
Pressing ,
[J], [K], [M] [N]
page 12-9). Pressing
[L]
in this chapter) that are resident in the FRM software.
0–2 . (The default is
.) (Port locations are shown in
0
Datab ase Sys tem Memory
As ync PAD As ync PAD
RS -232 RS -232
N N
autob aud autob aud
90 90
N N
0,n one 0,n one
N N
N N
[A],[C],[A]
, the letter will be displayed preceding the name in the
U
, or will display more parameters, listed in
[O]
will display the async PAD profile parameters (listed earlier
from the Main Menu.
[A], [C], [A]
0 .) (RLP locations are shown in
Figure 6-2.)
Table 12-3
Nod e Name=n odexyz
from Main Menu
[F7] to update the
Table 12-3
Frame Relay Module 4.0 User Guide, Rev 01
on page 12-
Initial
(on