Verify The Rear I/O Module - Oracle SPARC T8-4 Service Manual

See "Returning the Server to Operation" on page
7. Verify the rear I/O installation.
See "Verify the Rear I/O Module" on page
Related Information
"Rear I/O Module LEDs" on page 173
■
"Determine if the Rear I/O Module Is Faulty" on page 176
■
"Remove the Rear I/O Module" on page 176
■
"Verify the Rear I/O Module" on page 181
■
"Returning the Server to Operation" on page 191
■

Verify the Rear I/O Module

1. Ensure that you have completed the following:
Applied power to the server.
■
See "Connect Power Cords" on page
Started the system.
■
See "Power On the Server (Oracle ILOM)" on page
2. Verify that the System Service Required LED on the rear I/O module is not lit.
See "Rear I/O Module LEDs" on page
3. Log in to Oracle ILOM.
See "Log In to Oracle ILOM (Service)" on page
4. Start the faultmagmt shell.
-> start SP/faultmgmt/shell
Are you sure you want to start the faultmgmt shell (y/n)? y
faultmgmtsp>
5.
Use the fmadm faulty command to determine if the server is operating normally.
If a fault was detected, see
■
If no faults were detected, then the rear I/O module has been replaced successfully. No
■
further action is required.
191.
181.
191.
173.
32.
"Diagnostics Process" on page
Verify the Rear I/O Module
192.
26.
Servicing the Rear I/O Module 181