Oracle SPARC T8-4 Service Manual page 85

-> start /System
Are you sure you want to start /System (y/n)? y
Starting /System
e. Switch to the system console to view POST output.
Watch the POST output for possible fault messages. The following output indicates that
POST did not detect any faults:
-> start /HOST/console
...
0:0:0>INFO:
0:0:0>
0:0:0>POST:
0:0:0>Master set ACK for vbsc runpost command and spin...
Note -
at the OpenBoot prompt (ok) go to the next step.
f.
If the server remains at the OpenBoot prompt, type boot.
Return the virtual keyswitch to Normal mode.
g.
-> set /HOST keyswitch_state=Normal
Set 'keyswitch_state' to 'Normal'
h. Switch to the system console and type:
# fmadm faulty
If any faults are reported, refer to the diagnostics instructions described in
Managing Faults" on page
Switch to the Oracle ILOM command shell.
4.
5.
Run the show faulty command.
-> show faulty
Target | Property
--------------------+------------------------+-------------------------------
/SP/faultmgmt/0 | fru
/SP/faultmgmt/0 | timestamp
/SP/faultmgmt/0/ | sunw-msg-id
faults/0 |
/SP/faultmgmt/0/ | uuid
POST Passed all devices.
Return to VBSC.
The server might boot automatically at this point. If so, go to step f. If the server remains
| Value
| /SYS/PM0/CM0/CMP/BOB10/D0
| Dec 14 22:43:59
| SUN4V-8000-DX
|
| 3aa7c854-9667-e176-efe5-e487e520
25.
Verify a DIMM
"Detecting and
Servicing DIMMs 85