Table of Contents
Advertisement
Install a DIMM
Ensure you have the correct DIMMs for your server. See
DIMMs" on page
If you are populating a new processor module:
■
Ensure you have the correct DIMMs for your server. See
Configurations" on page
3.
Unpack the replacement DIMMs and place them on an antistatic mat.
4.
Ensure that the ejector tabs on the connector that will receive the DIMM are in
the open position.
5.
Align the DIMM notch with the key in the connector.
Caution -
is reversed.
6.
Push the DIMM into the connector until the ejector tabs lock the DIMM in place.
If the DIMM does not easily seat into the connector, check the DIMM's orientation.
7.
Repeat
82
SPARC T8-4 Server Service Manual • January 2022
71.
69.
Ensure that the orientation is correct. The DIMM might be damaged if the orientation
Step 4
through
Step 6
until all new DIMMs are installed.
"Identifying
"Understanding DIMM
Advertisement
Table of Contents
