Servicing the Rear Chassis Subassembly
For the location of the rear chassis subassembly, see
Caution -
discharge. This discharge can cause failure of server components.
Caution -
"Disconnect Power Cords" on page
"Rear Chassis Subassembly Components" on page 183
■
"Remove the Rear Chassis Subassembly" on page 184
■
"Install the Rear Chassis Subassembly" on page 187
■
"Verify the Rear Chassis Subassembly" on page 188
■
Related Information
"Identifying Components" on page 13
■
"Detecting and Managing Faults" on page 25
■
"Preparing for Service" on page 43
■
"Returning the Server to Operation" on page 191
■
Rear Chassis Subassembly Components
You remove and install the rear chassis subassembly as a single unit.
This procedure requires that you handle components that are sensitive to electrostatic
You must disconnect the power cords before servicing this component. See
"Rear Panel Components" on page
53.
Servicing the Rear Chassis Subassembly
15.
183
Need help?
Do you have a question about the SPARC T8-4 and is the answer not in the manual?
Questions and answers