Install the SPM
3.
Lower the other side of the SPM down and press down on the SPM to seat it into
the connectors on the motherboard.
4.
Install the main module back into the server.
See
"Install the Main Module" on page
5.
Connect a terminal or a terminal emulator (PC or workstation) to the SER MGT
port.
If the replacement SPM detects that the SPM firmware is not compatible with the existing host
firmware, further action is suspended and the following message is delivered over the SER
MGT port.
Unrecognized Chassis: This module is installed in an unknown or
unsupported chassis. You must upgrade the firmware to a newer
version that supports this chassis.
If you see this message, go on to
If you do not see this message, go to Step
Download the system firmware.
6.
Configure the SER MGT port to enable the firmware image to be
a.
downloaded.
Refer to the Oracle ILOM documentation for network configuration instructions.
b.
Download the system firmware.
Follow the firmware download instructions in the Oracle ILOM documentation.
Note -
that had been installed prior to the replacement of the SPM. However, Oracle strongly
recommends installing the newest version of the system firmware.
7.
Restore the service processor configuration information that you backed up
earlier.
At the Oracle ILOM prompt, type:
-> cd /SP/config
-> load -source uri target
where:
122
SPARC T8-4 Server Service Manual • January 2022
You can load any supported system firmware version, including the firmware revision
102.
Step
6.
Step
7.