Advertisement
Install Server Module and Verify STANDBY Power State
The system chassis should be powered on prior to installing the server module into the chassis. The server
module, by default, receives STANDBY power from the powered-on system chassis after inserting the server
module into the chassis. For information about powering on the system chassis, refer to the system chassis
documentation. For information about powering on the server module, refer to the Sun Blade X6270 Server
Module Installation Guide.
▼ Insert Server Module Into a Powered-On Chassis
1. Verify that the system chassis is powered on.
When the chassis is powered on, the fans are operating and the OK/Power LED illuminates a STEADY ON
green light. The OK/Power LED is located on both the front and rear panels of the chassis. If the chassis is
not powered on, refer to the system chassis documentation.
2. In the front of the chassis, locate and remove the filler panel from the slot where you will insert the server
module. Pull the lever out and eject the filler panel.
3. Position the server module vertically so that the ejectors are on the right and extend outward.
4. Push the server module into the slot until the server module stops and is flush with the chassis.
5. To lock the server module into the chassis, do the following:
Rotate the top ejector down until it snaps into place.
■
Rotate the bottom ejector up until it snaps into place.
■
The ejectors are locked and STANDBY power is applied to the server module service processor (SP).
Note –
The server SP can take several minutes to boot. As the server SP is booting, the OK/Power LED
illuminates a SLOW blink (0.5 second on, 0.5 second off). After the server SP boots, the OK/Power LED
illuminates a STANDBY blink (0.1 second on, 2.9 seconds off). The STANDBY blink state indicates that the
server SP is ready to be powered on.
▼ Verify STANDBY Power State on Server Module
1. Verify that the system chassis is powered on.
A STEADY ON green light (OK/Power LED) indicates that the chassis is powered on. If the chassis is not
powered on, refer to the system chassis documentation for instructions on powering on the system chassis.
2. Ensure that the OK/Power LED on the server module illuminates a STANDBY blink.
The OK/Power LED on the server module front panel illuminates a STANDBY blink (0.1 second on, 2.9
seconds off) to indicate that STANDBY power is supplied to the server module. The STANDBY blink
indicates that the server module SP is active but the server module host is powered off.
Note –
The OK/Power LED will be set to STANDBY blink only when there is enough chassis power for the
server module to power on. If there is insufficient chassis power, the OK/Power LED will remain off until there
is sufficient chassis power available. To troubleshoot, review the Integrated Lights Out Manager (ILOM) log
messages to determine whether the server module has permission to power on and refer to the system chassis
documentation for information about powering on components in the chassis.
2
Advertisement
