Verify The Rear I/O Module - Oracle SPARC T5-4 Service Manual

Verify the Rear I/O Module

4. Connect the cables to the appropriate ports on the rear I/O module.
5. Connect the power cords.
See "Connect Power Cords" on page
6. Power on the server.
See "Returning the Server to Operation" on page
Verify the rear I/O installation.
7.
See "Verify the Rear I/O Module" on page
Related Information
"Rear I/O Module LEDs" on page 173
■
"Determine if the Rear I/O Module Is Faulty" on page 175
■
"Remove the Rear I/O Module" on page 176
■
"Verify the Rear I/O Module" on page 180
■
"Returning the Server to Operation" on page 191
■
Verify the Rear I/O Module
1. Ensure that you have completed the following:
Applied power to the server.
■
See
Started the system.
■
See
2. Verify that the System Service Required LED on the rear I/O module is not lit.
See "Rear I/O Module LEDs" on page
Log in to Oracle ILOM.
3.
See "Log In to Oracle ILOM (Service)" on page
Start the faultmagmt shell.
4.
start SP/faultmgmt/shell
->
Are you sure you want to start the faultmgmt shell (y/n)?
faultmgmtsp>
5.
Use the fmadm faulty command to determine if the server is operating normally.
180 SPARC T5-4 Server Service Manual • July 2016
"Connect Power Cords" on page
"Power On the Server (Oracle ILOM)" on page
191.
191.
180.
191.
192.
173.
26.
y