Verify A Fan Module - Oracle SPARC T7-1 Service Manual

Related Information
"Return the Server to the Normal Operating Position" on page
■
"Remove a Fan Module" on page 75
■
"Verify a Fan Module" on page 81
■

Verify a Fan Module

1. Verify that the Service Required LED on the replaced fan module is not lit.
See "Fan Module LEDs" on page
2. Verify that the Top Fan LED and the Service Required LED on the front of the
server are not lit.
See "Front Panel Controls and LEDs" on page
If you are replacing a fan module when the server is powered down, the LEDs might
Note -
stay lit until power is restored to the server and the server can determine that the fan module is
functioning properly.
3.
Use the Oracle ILOM show faulty command to verify that the fault has been
cleared.
See "Identify Faulted Components" on page 24
command.
Consider these two possibilities.
If the previous steps did not clear the fault, see
■
Faults" on page 23
to diagnose component faults.
If the previous steps indicate that no faults have been detected, then the
■
component has been replaced successfully. No further action is required.
Related Information
"Determine Which Fan Module Is Faulty" on page 75
■
"Front Panel Components (Service)" on page 13
■
"Rear Panel Components (Service)" on page 15
■
74.
30.
for more information on using the show faulty
for information about the tools and methods you can use
Verify a Fan Module
179.
"Detecting and Managing
Servicing Fan Modules 81