Oracle SPARC T8-4 Service Manual page 115

-> start /SP/faultmgmt/shell
Are you sure you want to start /SP/faultmgmt/shell (y/n)? y
faultmgmtsp> fmadm faulty
a. If the output from the fmadm faulty command shows no faults, go to
b. If the output from the fmadm faulty command shows the replacement NVMe
switch card as disabled, go to
to clear the PSH-detected fault from the server.
2. Verify that the front and rear Service Required LEDs are not lit.
See "Front Panel Controls and LEDs" on page 29
LEDs" on page 30.
3. Consider these options:
If the previous steps did not clear the fault, see
■
If Step 1 and Step 2
■
has been replaced successfully. No further action is required.
Related Information
"Main Module Components" on page 20
■
"Remove the Main Module" on page 99
■
"Install the Main Module" on page 102
■
"Servicing the Main Module" on page 97
■
"Detecting and Managing Faults" on page 25
indicate that no faults have been detected, then the processor module
Verify a NVMe Switch Card
and "Rear Panel Controls and
"Diagnostics Process" on page 26
Servicing NVMe Switch Cards
Step 2.
115