Remove A Processor Module Or Processor Filler Module - Oracle SPARC T8-4 Service Manual

Remove a Processor Module or Processor Filler Module

"Processor Module LEDs" on page 58
■
"Remove a Processor Module or Processor Filler Module" on page 60
■
"Install a Processor Module or Processor Filler Module" on page 63
■
"Verify a Processor Module" on page 67
■
Remove a Processor Module or Processor Filler Module
Processor modules and processor filler modules are cold-service components that can be
replaced only after you power off the system. Processor modules can be replaced only
by qualified service personnel. For the location of the modules, see
Configuration" on page
Caution -
"Disconnect Power Cords" on page
Caution -
discharge. This discharge can cause failure of server components.
1. Prepare the server for service.
See "Preparing for Service" on page
2. Ensure that the server is powered off.
See "Removing Power From the Server" on page
Disconnect the power cords.
3.
See "Disconnect Power Cords" on page
4. Locate the processor module in the server that you want to remove.
If you are replacing a faulty processor module, see
■
Processor Module Is Faulty" on page 59
module.
If you are adding a processor module, remove the processor filler module in
■
slot 1.
60 SPARC T8-4 Server Service Manual • January 2022
57.
You must disconnect the power cords before servicing this component. See
This procedure requires that you handle components that are sensitive to electrostatic
53.
43.
50.
53.
to locate a faulty processor
"Processor Module
"Determine Which