System Schematic - Oracle SPARC T8-4 Service Manual

System Schematic

See "Returning the Server to Operation" on page
At the host prompt, determine whether the replaced FRU still shows a faulty
2.
state.
See "Check for Faults" on page
If no fault is reported, you do not need to do anything else. Do not perform
■
the subsequent steps.
If a fault is reported, continue to
■
Clear the fault from all persistent fault records.
3.
In some cases, even though the fault is cleared, some persistent fault information remains
and results in erroneous fault messages at boot time. To ensure that these messages are not
displayed, type this PSH command:
faultmgmtsp> fmadm acquit UUID
Verify the fault is cleared.
4.
Run the show disabled command to see if any components are still listed as faulty. If there are
disabled components, repair the faults manually and continue to the next step to reset the server.
faultmgmtsp> show disabled
If required, reset the server.
5.
faultmgmtsp> exit
-> reset /System
Are you sure you want to reset /System? y
Resetting /System ...
Related Information
"PSH Overview" on page 25
■
"Check for Faults" on page 33
■
System Schematic
This schematic shows the connections between and among specific components and device
slots. You can use this schematic to determine optimum locations for any optional cards or other
peripherals based on system configuration and intended use.
40 SPARC T8-4 Server Service Manual • January 2022
191.
33.
Step 3.