Verify The Spm - Oracle SPARC T8-4 Service Manual

Verify the SPM

a.
Set the datetime property, if necessary.
-> set /SP/clock datetime=MMDDhhmmYYYY
b.
Set the timezone property, if necessary.
-> set /SP/clock timezone=3-to-4-characters
where the timezone value equals a three- or four-character timezone abbreviation, such as
EST.
Related Information
"Determine if the SPM Is Faulty" on page 117
■
"Remove the SPM" on page 118
■
"Verify the SPM" on page 124
■
Verify the SPM
Verify that the SP LED on the main module or rear I/O module is lit green.
1.
See "Main Module LEDs" on page 98
2. Verify that the front and rear Service Required LEDs are not lit.
See "Interpreting LEDs" on page
3. Consider these options.
If the previous steps did not clear the fault, see
■
If the previous steps indicate that no faults have been detected, then the SPM has been
■
replaced successfully. No further action is required.
Related Information
"Determine if the SPM Is Faulty" on page 117
■
"Remove the SPM" on page 118
■
"Install the SPM" on page 121
■
124 SPARC T8-4 Server Service Manual • January 2022
or "Rear I/O Module LEDs" on page
27.
"Diagnostics Process" on page
173.
26.