Install The Rear Chassis Subassembly - Oracle SPARC T8-4 Service Manual

Install the Rear Chassis Subassembly

1. Slide the rear chassis subassembly into the server.
2. From the front of the server, tighten the five green screws that secure the rear
chassis subassembly in the server.
3. Remove the connector covers from the replacement rear chassis subassembly.
Install the following components:
4.
All four power supplies – see
■
Main module – see
■
Both processor modules or processor filler modules – see
■
Processor Filler Module" on page 63
5. Go to the rear of the server and install the following components:
Rear I/O module – see
■
All PCIe carriers or fillers – see
■
are installing the PCIe cards back in their original slots using the notes that you took when
removing the cards from the slots earlier.
All five fan modules – see
■
"Install a Power Supply" on page
"Install the Main Module" on page
"Install the Rear I/O Module" on page
"Install a PCIe Card Carrier" on page
"Install a Fan Module" on page
Install the Rear Chassis Subassembly
142.
102.
."Install a Processor Module or
178.
170. Verify that you
151.
Servicing the Rear Chassis Subassembly 187