Oracle SPARC T8-4 Service Manual page 100

Remove the Main Module
3. Disconnect the power cords.
See "Disconnect Power Cords" on page
4. Locate the main module in the server.
See "Front Panel Components" on page
5. Squeeze the release latches together on the two extraction levers, and pull the
extraction levers out to disengage the main module from the server.
Pull the main module halfway out of the server.
6.
7. Press the levers back toward the center of the main module.
This will keep the levers from being damaged when the main module is outside the server.
Caution -
perform. Do not attempt to lift the main module alone.
Remove the main module completely from the server.
8.
9. Consider your next steps:
If you have removed the main module to prepare the server for installation,
■
return to
Guide.
100 SPARC T8-4 Server Service Manual • January 2022
Due to the weight of the main module, the following step requires two people to
"Preparing for Installation" in SPARC T8-4 Server Installation
53.
14.