Verify The Spm - Oracle SPARC T7-2 Service Manual

Verify the SPM

See "Power On the Server (Oracle ILOM)" on page 174
Power Button)" on page
12. Verify the SPM.
See "Verify the SPM" on page
Related Information
Oracle ILOM documentation
■
"Remove the SPM" on page 136
■
"Verify the SPM" on page 140
■
Verify the SPM
1. Verify that the SPM Status LED is illuminated green.
The LED flashes green while the SPM initializes the Oracle ILOM firmware. See
LEDs" on page 35
2. At the Oracle ILOM prompt, start the fault management shell.
-> start /SP/faultmgmt/shell
Are you sure you want to start /SP/faultmgmt/shell (y/n)? y
faultmgmtsp>
3.
Type fmadm faulty to check for faults.
If faults are reported, see
■
If no faults are reported, then the SPM has been replaced successfully.
■
Related Information
Oracle ILOM documentation
■
"Install the SPM" on page 137
■
140 SPARC T7-2 Server Service Manual • July 2019
175.
140.
for information about the status of the SPM LED.
"Detecting and Managing Faults" on page 29
or "Power On the Server (System
.
"Interpreting