Verify The Spm - Oracle SPARC T8-2 Service Manual

Verify the SPM

For information about initializing TPM using the Oracle ILOM interface to enable failover,
see
b. Restore the TPM data and keys that were backed up to the new SP you
install.
For information about migrating or restoring TPM data and keys, see
and Attached Devices in Oracle Solaris
11. Power on the server.
See "Power On the Server (Oracle ILOM)" on page 174
Power Button)" on page
12. Verify the SPM.
See "Verify the SPM" on page
Related Information
Oracle ILOM documentation
■
"Remove the SPM" on page 130
■
"Verify the SPM" on page 134
■
Verify the SPM
1. Verify that the SPM Status LED is illuminated green.
The LED flashes green while the SPM initializes the Oracle ILOM firmware. See
LEDs" on page 33
2. At the Oracle ILOM prompt, start the fault management shell.
-> start /SP/faultmgmt/shell
Are you sure you want to start /SP/faultmgmt/shell (y/n)? y
faultmgmtsp>
3.
Type fmadm faulty to check for faults.
If faults are reported, see
■
If no faults are reported, then the SPM has been replaced successfully.
■
134 SPARC T8-2 Server Service Manual • June 2019
Securing Systems and Attached Devices in Oracle Solaris
175.
134.
for information about the status of the SPM LED.
"Detecting and Managing Faults" on page 27
11.3.
11.3.
or "Power On the Server (System
Securing Systems
"Interpreting
.