Table of Contents
Advertisement
Taking pictures after automatically setting the
aperture value and shutter speed
Recording mode:
Take pictures using automatic aperture values and shutter speed settings in accordance
with the brightness of a subject.
1
Set mode dial to [ ]
2
Press the shutter button halfway
• If the aperture value and shutter speed flash red, you do not have the correct
exposure.
3
While the numeric values are displayed
(approximately 10 seconds), rotate the
rear dial to change the values using
Program Shift
Program Shift indication
Aperture value
Shutter speed
• The operation can also be performed by rotating the control ring.
• To cancel Program Shift, either turn off the camera or rotate the rear dial until the
Program Shift indication turns off.
• Program Shift can easily be canceled by setting a function button to [One Push
AE].
(→47, 63)
About Program Shift
The function for maintaining the same exposure (brightness) while changing the aperture
value and shutter speed combination is called "Program Shift". You can use "Program
Shift" to take pictures by adjusting the aperture value and shutter speed even in Program
AE Mode.
●
Program Shift cannot be used in the following cases:
• When recording using the flash
• When recording 4K photos
• When recording using [Post Focus]
• When ISO sensitivity is set to [
57
]
Recording mode
(Program AE Mode)
60
250
125
p
60
30
15
4.0
5.6
8.0
Advertisement
Table of Contents
Need help?
Do you have a question about the Lumix DC-ZS200 and is the answer not in the manual?
Questions and answers
a take a photo with the dial set at P, push shutter and screen says "recording in Post focus" what does that mean? All I want is a single frame, not a movie.
On the Panasonic Lumix DC-ZS200, "recording in Post Focus" means the camera captures multiple images at different focus points when the shutter is pressed. You can then select and save the desired focus point later during playback. This feature is available when the mode dial is set to P (Program) and [Post Focus] is selected in the drive mode.
This answer is automatically generated