Taking Pictures After Automatically Setting The Aperture Value And Shutter Speed (Program Ae Mode); Program Shift - Panasonic LUMIX DC-FZ80 Owner's Manual

Taking pictures after automatically setting the
aperture value and shutter speed
Recording mode:
Take pictures using automatic aperture values and shutter speed settings in accordance
with the brightness of a subject.
1
Set mode dial to [
2
Press the shutter button halfway
• If the aperture value and shutter speed flash red, you do not have the correct
exposure.
3
While the numeric values are displayed
(approximately 10 seconds), rotate the
rear dial to change the values using

Program Shift

Program Shift indication
Aperture value
Shutter speed
• To cancel Program Shift, either turn off the camera or rotate the rear dial until the
Program Shift indication turns off.
• Program Shift can easily be canceled by setting a function button to [One Push
AE]. (→64)
About Program Shift
The function for maintaining the same exposure (brightness) while changing the aperture
value and shutter speed combination is called "Program Shift". You can use "Program
Shift" to take pictures by adjusting the aperture value and shutter speed even in Program
AE Mode.
●
Program Shift cannot be used in the following cases:
• When recording 4K photos
• When recording using [Post Focus]
• When ISO sensitivity is set to [
57
]
]
Recording mode
(Program AE Mode)
60
250 125
2.8 4.0
p
60 30 15
5.6 8.0
DVQP1223