Table of Contents
Advertisement
Recording motion pictures by setting the aperture/shutter speed/ISO sensitivity (Creative Video Mode)
4
3
Repeat step
Crop end frame
• The setting of [AF Mode] switches to [
Eye Detection cannot be used.)
5
Press the motion picture button (or shutter button) to
start recording
Elapsed recording time
Set operating time
• Immediately release the motion picture button (or shutter button)
after pressing it.
• When the set operating time has elapsed, recording
automatically ends. To end recording midway, press the motion
picture button (or the shutter button) again.
When you want to zoom in/out, set different angles of view for the cropping start and end
frames. For example, to zoom in, set a larger angle of view for the start frame and a smaller
angle of view for the end frame.
■
Changing the position and size of a crop frame
Press [Fn3] button while the recording screen is displayed, and perform steps
■
To cancel [4K Live Cropping] recording
Set [OFF] in step
●
The angle of view narrows.
●
[4K Live Cropping] recording cannot be performed when [High Speed Video] is set.
●
Focus is adjusted and fixed in the crop start frame.
●
[Continuous AF] is set to [OFF].
●
[Metering Mode] will be [
●
You cannot zoom in/out during [4K Live Cropping] recording.
80
, and then set the crop end frame
2
.
] (Multi Metering).
] (Face Detection). (The
Recording mode
End
End
Size
Size
Reset
Reset
3
4
and
Set
Set
.
Advertisement
Table of Contents
Need help?
Do you have a question about the Lumix DC-ZS200 and is the answer not in the manual?
Questions and answers
a take a photo with the dial set at P, push shutter and screen says "recording in Post focus" what does that mean? All I want is a single frame, not a movie.
On the Panasonic Lumix DC-ZS200, "recording in Post Focus" means the camera captures multiple images at different focus points when the shutter is pressed. You can then select and save the desired focus point later during playback. This feature is available when the mode dial is set to P (Program) and [Post Focus] is selected in the drive mode.
This answer is automatically generated