Table of Contents
Advertisement
Inserting the battery
To charge the battery, insert it into the camera.
1
Slide the release lever to the [OPEN]
position and open the card/battery door
Release lever
2
Insert the battery all the way
• Insert the battery all the way firmly and check
that it is locked by lever.
3
Close the card/battery door and then
slide the release lever to the [LOCK]
position
Make sure to insert the battery in the correct
orientation.
Lever
■
To remove battery
Move the lever in the card/battery
compartment in the direction of the arrow.
●
Always use genuine Panasonic batteries.
●
If you use other batteries, we cannot guarantee the quality of this product.
●
To remove the battery, turn the camera off and wait until the LUMIX indicator on the screen goes
off. (Failure to wait may cause the camera to malfunction and may damage the card or recorded
data.)
●
Remove battery from camera after use.
●
The unusable battery should be discarded in accordance with battery recycling laws.
Call the RBRC hotline at 1-800-822-8837 for information.
20
Preparations
Charging battery
[OPEN] [LOCK]
Advertisement
Table of Contents
Need help?
Do you have a question about the Lumix DC-ZS200 and is the answer not in the manual?
Questions and answers
a take a photo with the dial set at P, push shutter and screen says "recording in Post focus" what does that mean? All I want is a single frame, not a movie.
On the Panasonic Lumix DC-ZS200, "recording in Post Focus" means the camera captures multiple images at different focus points when the shutter is pressed. You can then select and save the desired focus point later during playback. This feature is available when the mode dial is set to P (Program) and [Post Focus] is selected in the drive mode.
This answer is automatically generated