Table of Contents
Advertisement
Taking pictures with Exposure Compensation
Recording mode:
Corrects the exposure when there is a backlight or when the subject is too dark or too
bright.
1
Press [
2
Rotate the rear dial to compensate the
exposure
Exposure Bracket
Exposure Compensation
• Press
Under-exposed
3
Press [MENU/SET] to set
• You can also press the shutter button halfway to set.
●
In Manual Exposure Mode, you can correct the exposure only when the ISO sensitivity is
set to [AUTO].
(You can select Exposure Compensation when the Quick menu is displayed by pressing
the [Q.MENU/
●
You can set the exposure compensation value in the range between –5 EV and +5 EV.
Settings can be made within a range of –3 EV to +3 EV while recording motion pictures, recording
4K photos, or recording in [Post Focus].
●
Depending on the brightness, this may not be possible in some cases.
●
When the Exposure Compensation value is out of the –3 EV to +3 EV range, the brightness of
the recording screen will no longer change. It is recommended to record by checking the actual
brightness of the recorded image in the Auto Review or playback screen.
●
The set Exposure Compensation value is stored even if the camera is turned off. (When [Exposure
Comp. Reset] is set to [OFF])
100
Focus, Brightness (Exposure) and Color tone Settings
] button (
)
to set the Exposure Bracket.
Adjust the
exposure to the [+]
direction
] button.)
(→128)
Optimum
exposure
Adjust the
exposure to the [-]
direction
OFF
Over-exposed
Advertisement
Table of Contents
Need help?
Do you have a question about the Lumix DC-ZS200 and is the answer not in the manual?
Questions and answers
a take a photo with the dial set at P, push shutter and screen says "recording in Post focus" what does that mean? All I want is a single frame, not a movie.
On the Panasonic Lumix DC-ZS200, "recording in Post Focus" means the camera captures multiple images at different focus points when the shutter is pressed. You can then select and save the desired focus point later during playback. This feature is available when the mode dial is set to P (Program) and [Post Focus] is selected in the drive mode.
This answer is automatically generated