Table of Contents
Advertisement
Message displays
The following explains the meaning of major messages displayed on the screen, and how
to respond to them.
■
Memory cards
[Memory Card Error] / [Format this card?]
• Save needed data on a computer or other device, and then use [Format] on the camera.
• Try with a different card.
[Read Error] / [Write Error] / [Please check the card]
• Check whether card has been inserted correctly (→25).
• Turn off the camera and remove the card. Reinsert the card and turn the camera on again.
• Try with a different card.
[Recording was cancelled due to the limitation of the writing speed of the card]
• The speed class of a required card varies depending on [Rec Format] and [Rec Quality] of a motion
picture. 4K photo recording requires a card that meets a particular speed class rating. Use a card
that meets the rating. Be sure to use a card of the recommended speed class (→26).
• If recording stops even when using a card of the recommended speed class (→26), the data writing
speed has dropped. If this happens, we recommend backing up the data on the memory card and
formatting it (→27). Depending on the type of the card, recording may stop in the middle.
[Memory Card Error] / [This memory card cannot be used]
• Use a compatible card.
■
Battery
[This battery cannot be used]
• Use a genuine Panasonic battery. Consult the dealer or your nearest Service Center if display still
remains.
• Wipe any dirt away from the battery terminal.
290
(→26)
Others
(→27)
Advertisement
Table of Contents
Need help?
Do you have a question about the Lumix DC-ZS200 and is the answer not in the manual?
Questions and answers
a take a photo with the dial set at P, push shutter and screen says "recording in Post focus" what does that mean? All I want is a single frame, not a movie.
On the Panasonic Lumix DC-ZS200, "recording in Post Focus" means the camera captures multiple images at different focus points when the shutter is pressed. You can then select and save the desired focus point later during playback. This feature is available when the mode dial is set to P (Program) and [Post Focus] is selected in the drive mode.
This answer is automatically generated