Rear Fender; Exhaust System Removal/Disassembly - Honda XL200 2001 Shop Manual

FAIRING/EXHAUST SYSTEM

REAR FENDER

Remove the seat and side covers.
Disconnect the tail/brake light and turn signal connectors.
Remove the bolts, collars and turn signal units.
Remove the mounting screws.
Pull the rear fender backward, then remove.
Install is in the reverse order of removal.
REAR FENDER BOLTS
CONNECTORS
EXHAUST SYSTEM
t
• Do not service the exhaust system while it is hot.
REMOVAL/ DISASSEMBLY
Remove the exhaust pipe joint nuts.
Loosen the exhaust pipe clamp and remove the muffler mounting
bolts.
Remove the muffler, exhaust pipe and gasket.
Remove the bolts, washers and muffler protector.
Remove the bolts, washers and exhaust pipe protector.
1 4 -4
REAR TURN SIGNAL LIGHT
BOLT
XL2 0 0
REAR FENDER